Super hydrophobic glass coating
Act as a sacrifical barrier coating over the surface of your car’s coat
Protect your car from aging,fading,weathering and erosion, sunshine, sour powder,industry powder,etc.
Protect your car from scratching, make the car more shining like the new
Only used in car paint
Effect can last about 1-3 monthsSpecifications:
Type:Car liquid ceramic coating
Material:Polysiloxane and other Nano materials etc
Gloss:Excellent high gloss effect, shiny as mirror
Dry time:5 minutes
Anti-corrosion:PH tolerance: PH2-12
Heat Resistance:Up to 760 degree
Bottle Size:As the picture
How to apply:
1、Wash the surface, then completely dry
2、Pour small amount of QUICK DRY CERAMIC COATING onto applicator pad or cotton round, cover entire panel with a thin coating, allow to dry for 1-3 minutes depending on temperature.
3. Finish buff with a dry microfiber towel.
4.Application of QUICK DRY CERAMIC COATING should be done on a single panel at a time (e.g. hood, fender, trunk) ensuring complete coverage and reducing the possibility of letting the product dry too long.
5 minutes dry
Question and Answer
Q:What is the advantage of AUTOCARE COATING PRODUCTS over polyurethane clear coats that already provide significant gloss and color retention?
A:AUTOCARE COATING PRODUCTS provides additional gloss and protection shield over clear coats. The ceramic resin bonded coating helps contaminants slide off easily, which give them less time to eat into the surface. An added plus is the ease of cleaning your vehicle. An easy way to think of it would be that System X is the equivalent of another, harder and glossier clear coat layer.
Q:Can I wax or seal over AUTOCARE COATING PRODUCTS?
A:Yes, if desired waxing and sealing over THE coatings won’t damage it. Let System X coatings cure for at least 24 hours before applying another product.
Q:Why does it seem that the water repellency has decreased over time?
A:This will happen over time due to eventual buildup of contaminants (like every other coating). Just clean the surface with a mild cleaner and wash off thoroughly with water. The hydrophobic effect is then reproduced.
Q:What must be removed from the exterior paint prior to application?
A:Transit wrap, tape or glue lines, bug residue, road tar, and any other contaminants. All polishing must be done prior to application. Use a 20-50% IPA to water mix to mist the paint and wipe down with microfiber towel to remove these residues. An paint shop safe prep-solvent will also do the trick.
Q:Can IT be applied using a HVLP spray gun?
A:Yes, IT can be applied using a HVLP spray gun, however Pro and Diamond should be applied by hand.